Transmit Abort Timeout - Intermec Janus 2050 User Manual

Transmit Abort Timeout

Purpose: Defines the length of time the JANUS 2050 waits to receive a message if one of
the following conditions is true:
• CTS is continuously false for the timeout period.
• XOFF condition does not change within the timeout period.
• POL not received (polling protocol) within the timeout period.
This is similar to the Timeout Delay configuration, but it only applies to the
three conditions listed above.
Note: You must select the communications port and protocol before setting the
parameters that define the protocol. Refer to the configuration command
"Communications Protocol, Configure" earlier in this chapter for more information on
defining protocols.
Default: Disabled
Syntax: IHdata
Acceptable values for data are:
0
1-65000
1. Scan the following bar code:
2. Scan a numeric value of one to five digits for data from the following bar
Disabled
Timeout in ms
Enter Accumulate / Transmit Abort Timeout
*+/$+IH*
*+/$+IH*
codes:
*0*
*0*
*2*
*2*
39 nugget A
Configuration Commands
*1*
*1*
*3*
*3*
10
10-91