Address, Multi-Drop - Intermec Janus 2050 User Manual

Address, Multi-Drop

Purpose: Defines the address of the communications port when using Multi-Drop
protocol. Each address has unique POL and SEL characters that are
automatically set when the address is configured. Refer to Appendix A for the
POL and SEL values that correspond to each address.
Note: You must select the communications port and protocol before setting the
parameters to define that protocol. For help, see "Communications Protocol,
Configure" later in this chapter.
Default: A
Syntax: HCdata
data can be A through Z or 0 through 5.
Scan: 1. Scan the following bar code:
2. Scan a bar code for data from the full ASCII chart in Appendix A.
3. Scan the following bar code:
Enter Accumulate / Address
*+/$+HC*
*+/$+HC*
Exit Accumulate
*-/*
*-/*
39 nugget A
Configuration Commands
10
10-5