Preparing To Use I/O Cards; Configuring The Janus Device To Use An I/O Card - Intermec Janus 2050 User Manual

4. Press G , the letter of the PC card drive. The program displays the next
prompt:
This command will erase drive G: entirely.
Do you want to continue (Y/N)?
5. Press Y to begin erasing the flash card. The program displays the next
message and the percent complete as it erases the card. Do not remove the
flash card while the program is erasing the card.
DO NOT REMOVE CARD WHILE ERASING!
Erasing card.
100% complete
Press return for main menu.
6. Press e to return to the MCFORMAT main menu.
7. Press d to exit MCFORMAT. You are ready to format the flash card.

Preparing to Use I/O Cards

You can use I/O expansion cards in the PC card drive. To use an I/O card in
the drive, you need to add the I/O card drivers and utilities to
AUTOEXEC.BAT and CONFIG.SYS.
Note: Before you use an I/O card in your JANUS device, read the documentation
shipped with the PC card for any instructions on using your card. Some cards may
need to be configured before they can be used in the PC card drive.

Configuring the JANUS device to Use an I/O Card

Follow these steps to configure the JANUS device for an I/O card:
1. Edit the AUTOEXEC.BAT file, which is stored on the drive C.
2. Search for this line in the AUTOEXEC.BAT file:
d:\apm_4m.exe
If the line is remarked out, delete the REM characters. If you cannot find
this line, add it to the AUTOEXEC.BAT file.
3. Remark out this line:
d:\ipm_4m.exe
Note: Do not load both IPM_4M.EXE or APM_4M.EXE at the same time.
4. Save your changes to the AUTOEXEC.BAT file.
5. Edit the CONFIG.SYS file on the JANUS drive C.
39 nugget A Using PC Cards
5
5-15