Running Interlnk On The Janus 2050 - Intermec Janus 2050 User Manual

nubbet nubbet code30

Running Interlnk on the JANUS 2050

If you are going to make the JANUS 2050 the client and make the host
computer the server, follow these instructions:
1. Start the Interlnk server by entering at the host computer's command
prompt:
intersvr
If you are using a port other than COM1, specify that port in the command
line (for example, intersvr /com2).
A screen appears displaying information on the redirected drives and
printer ports.
2. Reboot the JANUS 2050 to start Interlnk by pressing c a f . .
Note: It is not necessary to modify the JANUS 2050 CONFIG.SYS file. The
JANUS 2050 factory default CONFIG.SYS file installs Interlnk automatically
(using the /auto option) when the JANUS 2050 is connected to a host computer
that is running Intersvr.
Caution
Do not press any keys while the JANUS 2050 is performing a warm boot or
you may lose data.
CAUTION
Conseil
N'appuyez pas sur des touches pendant que le lecteur se réamorce, sinon
vous pouvez perdre des données.
Interlnk is now connected to the server and you are ready for operation. For
example, if the client's (JANUS 2050) drive G is redirected from the server's
drive A, enter the following command:
g:
Now any commands entered at the drive G prompt will affect the host
computer's drive A.
Interlnk\Intersvr can also be executed on two JANUS 2050s using the steps
listed above.
ode30
iconCommunicating With the JANUS 2050
icon
6
6-17