Intermec Janus 2050 User Manual page 151

JANUS 2050 Vehicle-Mount Computer User's Manual
If you want to load a protocol handler for a designated port and execute
Communications Manager, you can include an argument in the command line.
To load a protocol handler, enter the following command at the DOS prompt:
cmgr -[{ port }{ ph }]
where:
port indicates the port for which you are loading the protocol handler. To load
the protocol handler for COM1, enter 1.
ph is the notation for the protocol handler you want to load. For the Intermec
protocol handler, enter i. For the PC Standard protocol handler, enter p.
For example, to load the PC Standard protocol handler on COM1 and execute
Communications Manager, enter the following command at the DOS prompt:
cmgr -1p
Note: When Communications Manager is used with the PC Standard protocol
handler, it automatically sets EOR to <CR><LF>, and EOF to <SOH> for file
transfers.
In the menu bar, there are three pull-down menus:
Cfg Select the Cfg menu to set the communications protocol for each of the
JANUS 2050 COM ports and define the parameters for each selected protocol.
For a list of the communications protocols and their parameters, see Chapter
10, "Configuration Commands."
Stat Select the Stat menu to view the status of the selected COM port, such as
the protocol and parameters being used and whether the port is active or
inactive.
6-20
Communications
File Cfg Stat
(4MB)nubbet nubbet code30
File Select the File menu to designate
which port to communicate through, and
transmit or receive ASCII files. It also has a
section that displays the software version.
You quit Communications Manager by
choosing Exit from this menu.
2050U-030
ode30
icon icon