Req (Request For Acknowledge) - Intermec Janus 2050 User Manual

JANUS 2050 Vehicle-Mount Computer User's Manual (4MB)

REQ (Request for Acknowledge)

Purpose: Enables/disables a request for a repeat handshake event. If REQ is enabled,
AFF and NEG must also be enabled to have a valid configuration.
Note: You must select the communications port and protocol before setting the
parameters that define the protocol. Refer to the configuration command
"Communications Protocol, Configure" earlier in this chapter for more information on
defining protocols.
Default: Disabled
Syntax: PDdata
data can be any ASCII character.
Scan: To disable REQ, scan the following bar code:
Disable REQ
*$+PD*
*$+PD*
Or: To set REQ to an ASCII character:
1. Scan the following bar code:
2. Scan a bar code for data from the full ASCII chart in Appendix A.
3. Scan the following bar code:
10-78
Enter Accumulate / REQ
*+/$+PD*
*+/$+PD*
Exit Accumulate
*-/*
*-/*
39 nugget A