Running Irl - Intermec Janus 2050 User Manual

code 39
nugget
helcond

Running IRL

This table lists problems that may occur when you run IRL programs on the
JANUS 2050. For more information, see Chapter 7, "Working With IRL."
Problem
The JANUS 2050 displays
"Executing..." on power up or
prompts you for data on power up.
There is not enough memory to run
your IRL program.
The JANUS 2050 is locked up in an IRL
program.
The JANUS 2050 displays "Insufficient
memory" when you try to run an IRL
program from the IRL Desktop
(IRLDESK.EXE).
39 nugget
Solution
An IRL program is running. Enter or scan the Exit IRL
program command shown below.
Exit IRL Program
*/$*
*/$*
Use IRLXDESK.EXE to execute the IRL program without the
IRL Desktop. You need to load IRLXDESK.EXE onto one of
the JANUS 2050 drives from the Boot companion disk. Once
it is loaded on the JANUS 2050, type the following command
and press e .
irlxdesk filename
No protocol handlers are loaded.
To break out of the IRL program, execute the application
break sequence:
1. Press the q button to turn the JANUS 2050 off.
2. Press n - 2 - b .
3. Press 1 .
4. Press the q button to turn the JANUS 2050 on.
You may be able to free up more conventional memory by
following the suggestions in "Making More RAM Available
on the JANUS 2050" in Chapter 11, "Advanced Operations."
Use the IRLXDESK utility, instead of the IRL Desktop, to run
the IRL program. IRLXDESK uses less conventional memory
than the IRL Desktop and does not provide the IRL Desktop
menu environment.
8
A Troubleshooting
8-9