Configuring The Janus 2050 From The Dos Prompt; Loading A New Configuration File; Automatically Loading A Configuration File - Intermec Janus 2050 User Manual

Configuring the JANUS 2050 From the DOS Prompt

You can create, load, and save configuration files by using switches with the ic
command at the DOS prompt. The switches are:
Command
ic /l { path\filename }
ic /s { path\filename }
ic /d
where path is the drive and directory that contains the file, and filename is the
name of the configuration file.
These commands do not execute the menu-driven configuration application
(IC.EXE). The menu-driven application executes when you type the ic
command without any switches or parameters.

Loading a New Configuration File

You can make any configuration file active by typing this command at the DOS
prompt:
ic /l { path\filename }
When you type this command, the JANUS 2050 displays this message:
Loading Reader
Configuration from
{ path\filename }
The configuration file specified in the message is now active.

Automatically Loading a Configuration File

You can make any configuration file load automatically whenever you boot the
JANUS 2050 by adding this command to the AUTOEXEC.BAT file:
ic /l { path\filename }
The JANUS 2050 will automatically load the configuration file whenever the
AUTOEXEC.BAT file executes.
nuggJVMU nugg JVMUConfiguring the JANUS 2050
Description
Loads a configuration file.
Saves a configuration file.
Loads the factory default configuration.
4
4-11