Irl End Program Block - Intermec Janus 2050 User Manual

IRL END Program Block

Purpose: Indicates the last block of an IRL program when downloading a program to the
JANUS 2050.
Note: You must select the communications port and protocol before setting the
parameters to define that protocol. Refer to the configuration command
"Communications Protocol, Configure" earlier in this chapter for more information on
defining protocols.
Default: SO (shift out)
Syntax: XDdata
data can be any ASCII characters.
Scan: To disable END, scan the following bar code:
Disable END
*$+XD*
*$+XD*
To set END to an ASCII character:
Or:
1. Scan the following bar code:
2. Scan a bar code for data from the full ASCII chart in Appendix A.
3. Scan the following bar code:
Enter Accumulate / End of IRL Program Block
*+/$+XD*
*+/$+XD*
Exit Accumulate
*-/*
*-/*
39 nugget A
Configuration Commands
10
10-57