Multi-Drop, User-Defined - Intermec Janus 2050 User Manual

Multi-Drop, User-Defined

An option of User-Defined protocol. You must set the POL and SEL characters
Purpose:
to define a unique device address. Refer to Appendix A for the correct POL and
SEL combinations.
Note: You must select User-Defined protocol before you can enable User-Defined
Multi-Drop protocol. Refer to the configuration command "Communications Protocol,
Configure"earlier in this chapter for more information on defining protocols. To
activate User-Defined Multi-Drop protocol, select User-Defined in the configuration
command Communications Protocol, Activate.
Default: Disabled
Syntax: PMdata
Acceptable values for data are:
0
1
Scan: One of the following labels:
Disable User-Defined Multi-Drop
*$+PM0*
*$+PM0*
Enable User-Defined Multi-Drop
*$+PM1*
*$+PM1*
39 nugget
Disabled
Enabled
A
Configuration Commands
10
10-41