Intermec Janus 2050 User Manual page 244

Code 49 (continued)
To disable any of the function codes, scan the appropriate label:
Disable Function Code 1
*$+CK*
*$+CK*
Disable Function Code 3
*$+CM*
*$+CM*
Or: To set one of the function codes to a character string:
1. Scan the appropriate bar code:
2. Scan any character from the full ASCII chart in Appendix A. Two
3. Scan the following bar code:
Enter Accumulate / Function Code 1
*+/$+CK*
*+/$+CK*
Enter Accumulate / Function Code 2
*+/$+CL*
*+/$+CL*
Enter Accumulate / Function Code 3
*+/$+CM*
*+/$+CM*
characters each are allowed for function code 1 and 3. Four characters are
allowed for function code 2.
Exit Accumulate
*-/*
*-/*
39 nugget A
Configuration Commands
Disable Function Code 2
*$+CL*
*$+CL*
10
10-25