Pol - Intermec Janus 2050 User Manual

POL

Purpose: Solicits or requests data from a polled device.
Note: You must select the communications port and protocol before setting the
parameters that define the protocol. Refer to the configuration command
"Communications Protocol, Configure" earlier in this chapter for more information on
defining protocols.
Default: Disabled
Syntax: HBdata
data can be any ASCII character.
Scan: To disable POL, scan the following bar code:
Disable POL
*$+HB*
*$+HB*
Or: To set POL to an ASCII character:
1. Scan the following bar code:
2. Scan a bar code for data from the full ASCII chart in Appendix A.
3. Scan the following bar code:
Enter Accumulate / POL
*+/$+HB*
*+/$+HB*
Exit Accumulate
*-/*
*-/*
39 nugget A
Configuration Commands
10
10-73