Irl Eop (End Of Program) - Intermec Janus 2050 User Manual

JANUS 2050 Vehicle-Mount Computer User's Manual (4MB)

IRL EOP (End of Program)

Purpose: An EOP indicates the end of an IRL program block when downloading a
program to the JANUS 2050.
Note: You must select the communications port and protocol before setting the
parameters to define that protocol. Refer to the configuration command
"Communications Protocol, Configure" earlier in this chapter for more information on
defining protocols.
Default: SYN (synchronous idle)
Syntax: XBdata
data can be any ASCII character.
Scan: To disable EOP, scan the following bar code:
Disable EOP
*$+XB*
*$+XB*
Or: To set EOP to an ASCII character:
1. Scan the following bar code:
2. Scan a bar code for data from the full ASCII chart in Appendix A.
3. Scan the following bar code:
10-58
Enter Accumulate / EOP
*+/$+XB*
*+/$+XB*
Exit Accumulate
*-/*
*-/*
39 nugget A