SOM (Start of Message)
Purpose:
SOM is the first character in a message sent to or received from the host
computer.
Note: You must select the communications port and protocol before setting the
parameters that define the protocol. Refer to the configuration command
"Communications Protocol, Configure" earlier in this chapter for more information on
defining protocols.
Default:
Disabled
Syntax:
PEdata
data can be any ASCII character
Scan:
To disable SOM, scan the following bar code:
Disable SOM
*$+PE*
*$+PE*
To set SOM to an ASCII character:
Or:
1. Scan the following bar code:
2. Scan a bar code for data from the full ASCII chart in Appendix A.
3. Scan the following bar code:
Enter Accumulate / SOM
*+/$+PE*
*+/$+PE*
Exit Accumulate
*-/*
*-/*
39 nugget
A
Configuration Commands
10
10-87