Key Code Lookup Table - Intermec Janus 2050 User Manual

Key Code Lookup Table

Purpose: Allows scanned characters to be remapped to keystroke equivalents. Up to 20
characters can be redefined.
Default: 102-key PC keyboard (no modifications)
Syntax: WMdata
Acceptable values for data are any ASCII character.
Scan: To reset the lookup table to the default setting, scan the following bar code:
Clear Lookup Table
*$+WN*
*$+WN*
Or: To modify any scanned character, complete the following steps:
1. Scan the following bar code:
2. Enter data by scanning the ASCII character you wish to redefine from the
3. Enter the new key by scanning the four-digit hex value from the full ASCII
4. Scan the Exit Accumulate bar code:
Modify Lookup Table
*+/$+WM*
*+/$+WM*
full ASCII chart in Appendix A.
chart in Appendix A. Refer to the Key Codes table in Appendix A for the
key's hex value.
Note: The redefined character and ASCII value should be enclosed in quotes to
prevent the JANUS 2050 from interpreting the option as a JANUS 2050 or
configuration command. For example, $+WM"A1A5B" is interpreted as, redefine
A to [ (hex value 1A5B).
Exit Accumulate
*-/*
*-/*
39 nugget A
Configuration Commands
10
10-63