Intermec Janus 2050 User Manual page 191

JANUS 2050 Vehicle-Mount Computer User's Manual (4MB)
Operating the JANUS 2050 (continued)
Problem
The user-application program is not
receiving the bar code input properly.
You want to return to the default (out
of the box) condition.
The JANUS 2050 may sound an error
beep and display an error message
such as "Bad command or filename"
when you attempt to scan a bar code
label that contains a valid
configuration command. Or, the
JANUS 2050 may reject configuration
commands sent over an RF link.
8-8
39 nugget
Solution
Reader Services may have been unloaded. Verify that the
command IF EXIST D:\RDG.BAT CALL D:\RDG.BAT is listed
in the AUTOEXEC.BAT file, and then perform a warm boot to
reload Reader Services. If Reader Services is not loaded, the
JANUS 2050 will not read the label at all.
Caution
Do not press any keys while the JANUS 2050 is
performing a warm boot or you may lose data.
Conseil
Lorsque le lecteur s'amorçe à froid, les données se
trouvant sur le disque RAM sont détruites.
Load the default configuration from the configuration
application (IC.EXE). At the DOS prompt, type the command ic
and press e . Using the arrow keys, choose File on the main
menu and press e . In the File drop-down menu, choose Load
Default and press e . To exit the configuration application,
choose Exit and press e .
Make sure the Configuration Manager TSR is loaded into the
JANUS 2050's memory. A JANUS 2050 accepts configuration
commands only if the TSR is loaded.
To load the Configuration Manager TSR, type the following
command and press e .
cfgmgr
A