Changing The Password; Putting The Janus 2050 In Storage Mode - Intermec Janus 2050 User Manual

JANUS 2050 Vehicle-Mount Computer User's Manual (4MB)

Changing the Password

The password is used to limit access to the Boot Loader menu. If the password
is set, you cannot access the options in the Boot Loader menu without the
password. Also, if you put the JANUS 2050 in Storage mode, you cannot exit
Storage mode without the password. If you lose the password, call your
Intermec service representative.
To set or change the password
1. If the Boot Loader menu is not already displayed on the JANUS 2050,
5. Type the new password again for verification and press e .
6. Select Resume from the Boot Loader menu.

Putting the JANUS 2050 in Storage Mode

If you are not going to use the JANUS 2050 for the next couple of months, you
should put it in Storage mode to preserve the life of the internal battery.
Caution
Any data stored in the JANUS 2050's memory is lost when you enter Storage
mode.
CAUTION
Conseil
Toutes les données stockées dans la mémoire du lecteur sont perdues lorsque
vous entrez en mode de stockage.
11-6
request the menu by turning the JANUS 2050 off. Then press n - 2 - b
followed by 2 followed by q.
Boot Loader
Reboot
Password
Dump
Load
Resume
Storage
Off
If you enter it incorrectly the second time, you receive an error message and
you need to repeat Steps 4 and 5 again.
39 nugget A
2. Using j , select Password.
3. Press e .
4. Type the new password and press
e . The password can be up to
seven characters.
2050U.102
To disable the password, press e
twice without typing in a password.