Eor (End Of Record) - Intermec Janus 2050 User Manual

JANUS 2050 Vehicle-Mount Computer User's Manual (4MB)

EOR (End of Record)

Purpose: Attaches an EOR to the end of every record of a file transmit.
Note: You must select the communications port and protocol before setting the
parameters to define that protocol. Refer to the configuration command
"Communications Protocol, Configure" earlier in this chapter for more information on
defining protocols.
The configured option may be overridden when used with certain communications
protocols. It will not be overridden when used with User-Defined protocol.
Default: Disabled
Syntax: FBdata
data can be one or two ASCII characters.
Scan: To disable EOR, scan the following bar code:
Disable EOR
*$+FB*
*$+FB*
Or: To set the EOR character to an ASCII character(s):
1. Scan the following bar code:
2. Scan one or two bar codes for data from the full ASCII chart in
3. Scan the following bar code:
10-50
Enter Accumulate / EOR
*+/$+FB*
*+/$+FB*
Appendix A.
Exit Accumulate
*-/*
*-/*
39 nugget A