Intermec Janus 2050 User Manual page 80

nugg nuggJVMU
To create an image file
1. The default startup files are installed on your host computer in the
subdirectory C_FILES\COMMON. You can create an image file that
contains only the startup files, other files in addition to the startup files, or
specific files. Use one of the following commands on the host computer to
create and load the image file:
• To create an image file containing the startup files in the subdirectory
C_FILES\COMMON and load the image file on the JANUS 2050 drive
C, type one of the following commands on the host computer.
Note: Any files residing on drive C are overwritten.
If the JANUS 2050 is going to operate in English, type:
load_usa
If the JANUS 2050 is going to operate in a language other than English,
type:
loadlang
• To create an image file containing the startup files in the subdirectory
C_FILES\COMMON plus any additional files and load it on the JANUS
2050 drive C, type the following command on the host computer:
loadnew {[ path\ ][ filename1 ]
Note: Any files residing on drive C are overwritten.
• To create an image file containing specific files and load it on the
JANUS 2050 drive C without replacing the JANUS 2050s current files,
type the following command on the host computer:
loadadd {[ path\ ][ filename1 ]
JVMUUsing the JANUS 2050 Software
[ path\ ][ filename2 ]} ...
[ path\ ][ filename2 ]} ...
3
3-17