Records Per Block - Intermec Janus 2050 User Manual

JANUS 2050 Vehicle-Mount Computer User's Manual (4MB)

Records Per Block

Purpose: Defines the maximum number of data records transmitted per block of data.
Usually files are transmitted record by record. This configuration allows
multiple records to be transmitted per data block. A block of data is
transmitted during a single transmission, like an individual data record is
normally.
Note: The configured option may be overridden when used with certain
communications protocols. It will not be overridden when used with User-Defined
protocol.
You must select the communications port and protocol before setting the parameters
that define the protocol. Refer to the configuration command "Communications
Protocol, Configure" earlier in this chapter for more information on defining protocols.
Default: 1 record transmitted per block
Syntax: FCdata
Acceptable values for data are:
0
01-99
Scan: To have all records transmitted in one block, scan the following bar code:
All Records = 1 Block
*$+FC0*
*$+FC0*
Or: To set the records per block:
1. Scan the following bar code:
10-76
All records are transmitted in one block
Records transmitted per block
Enter Accumulate / Number of Records Per Block
*+/$+FC*
*+/$+FC*
39 nugget A