Intermec Janus 2050 User Manual page 268

EOM (End of Message continued)
2. Scan one or two bar codes for data from the full ASCII chart in
3. Scan this bar code:
Or: To set EOM transmit and receive to different ASCII characters:
Note: You can enable an EOM transmit character and disable the EOM receive
character, or vice versa.
1. Scan this bar code to set the EOM transmit character:
2. Scan one or two bar codes for data from the full ASCII chart in
3. Scan this bar code:
4. Scan this bar code to set the EOM receive character:
5. Scan one or two bar codes for data from the full ASCII chart in
6. Scan this bar code:
Appendix A.
Exit Accumulate
*-/*
*-/*
Enter Accumulate / Enable EOM, Transmit Only
*+/$+PI*
*+/$+PI*
Appendix A.
Exit Accumulate
*-/*
*-/*
Enter Accumulate / Enable EOM, Receive Only
*+/$+PJ*
*+/$+PJ*
Appendix A.
Exit Accumulate
*-/*
*-/*
39 nugget A
Configuration Commands
10
10-49