Using Dos Commands - Intermec Janus 2050 User Manual

Companion disk 3 The Application companion disk contains applications such
as Communications Manager and IRLXDESK.EXE. This disk also contains PC
card drivers and utilities that control the reader's operation, prepare the reader
to use the different types of PC cards, customize the reader to use the PC card
software, and provide you with helpful tools.
Note: Companion disk 3 also contains LDKEYTAB.EXE and a .KTB file. Only an
authorized Intermec service technician should use these files to load the keypad scan
code table.

Using DOS Commands

Your JANUS device uses the MS-DOS operating system, and you can use DOS
commands on the JANUS device just as you do on a PC. From the DOS
prompt, you type a DOS command and press
example:
dir
Or, you can create and scan bar code labels that contain DOS commands:
DIR Command
*DIR*
*DIR*
For help using DOS commands, see any DOS manual.
All DOS commands provided with the JANUS device are available on the
MS-DOS Programs companion disk 2. The most commonly used commands
are also stored on drive D. See the README.DOC for a list of the files on
drive D.
Note: The DOS commands available on drive D are a subset of the DOS commands
that are available on the MS-DOS companion disk. You can add or replace DOS
commands on drive D as needed.
Your 4MB JANUS device supports these commands, but you cannot use them
on drives C or D because they are ROM (read only memory) drives:
CHKDSK (You can analyze, but not fix, drives C and D with CHKDSK)
DISKCOMP
DISKCOPY
SCANDISK (You can analyze, but not fix, drives C and D with SCANDISK)
DEFRAG (DEFRAG will not work on drives C and D)
nuggJVMU nugg JVMUUsing the JANUS 2050 Software
(
to execute the command. For
3
3-5