Eof (End Of File) - Intermec Janus 2050 User Manual

EOF (End of File)

Purpose: Defines the end of file character for the communications port when
transmitting a file from the JANUS 2050.
Note: You must select the communications port and protocol before setting the
parameters to define that protocol. Refer to the configuration command
"Communications Protocol, Configure" earlier in this chapter for more information on
defining protocols.
The configured option may be overridden when used with certain communications
protocols. It will not be overridden when used with User-Defined protocol.
Default: Disabled
Syntax: FAdata
data can be any ASCII character.
Scan: To disable EOF, scan the following bar code:
Disable EOF
*$+FA*
*$+FA*
Or: To set EOF to an ASCII character:
1. Scan the following bar code:
2. Scan a bar code for data from the full ASCII chart in Appendix A.
3. Scan the following bar code:
Enter Accumulate / EOF
*+/$+FA*
*+/$+FA*
Exit Accumulate
*-/*
*-/*
39 nugget A
Configuration Commands
10
10-47