Setting Up The Janus 2050 For Communications; Configuring The Janus 2050 For Communications - Intermec Janus 2050 User Manual

nubbet nubbet code30

Setting Up the JANUS 2050 for Communications

1. Select and configure the communications port and protocol.
2. Load the corresponding protocol handler, if necessary.
3. If you are not loading a protocol handler, set the configuration parameters
4. Connect the JANUS 2050 to the device it will communicate with.
Each step is explained in the following pages.

Configuring the JANUS 2050 for Communications

When configuring the JANUS 2050 to talk to another device, it is important that
the JANUS 2050 and connecting device are set to the same communications
protocol and parameters. The communications protocols have one or more
parameters that must be configured for that protocol.
To configure the JANUS 2050 for communications
1. Select the communications port for which you are configuring the protocol.
2. Select the protocol you want to configure. Your selection tells the JANUS
3. Set the parameters for that protocol. (See "Communications Protocol,
4. Activate the selected protocol. The port cannot use the communications
You can configure the JANUS 2050 port for more than one communications
protocol, but the port can only use one protocol at a time. You designate what
protocol a port should have by "activating" it in the JANUS 2050's
configuration. When you are using a communications program on the JANUS
2050, the RF port is designated as COM4.
Note: If you are using a CrossBar network, configure the JANUS 2050 for Multi-Drop
protocol.
ode30
iconCommunicating With the JANUS 2050
icon
for communications port UART (Universal Asynchronous
Receiver/Transmitter).
Your selection tells the JANUS 2050 to apply all further communication
configurations to the selected port. (See "Communications Port, Select" in
Chapter 10.)
2050 to apply all further communications parameter configurations to the
selected protocol. (See "Communications Protocol, Configure" in
Chapter 10.)
Configure" in Chapter 10 for a list of parameters for each protocol.)
protocol until it is active. (See "Communications Protocol, Activate" in
Chapter 10.)
6
6-7