Intermec Janus 2050 User Manual page 320

Password Select this option to set, change, or disable the current password.
When the password is set, you must enter a password before you can go to the
Boot Loader menu.
Dump This selection transmits the lower 640K of memory across the serial
port. It is used when the JANUS 2050 is not functioning and you need to save
the data.
Before selecting this option, the host computer must be connected to the
JANUS 2050 and executing a program that expects the 640K of data. For more
information about dumping data, see Chapter 8, "Troubleshooting."
Load Select this option to receive a program across the serial port. The
program may be a transient loader capable of programming the flash, a
program to reload a corrupted keypad table, or execute diagnostics. For more
information about loading programs, see Chapter 8, "Troubleshooting."
Caution
If the load system flash option is selected, all system data will be lost.
CAUTION
Conseil
Si l'option de chargement du flash système (load system flash) est sélectionnée,
toutes les données système seront perdues.
Resume This selection exits the Boot Loader menu and returns the JANUS
2050 to where it was before it was turned off. If the JANUS 2050 was executing
a program, the program continues. If there is a bad checksum or the flash is
corrupt, the JANUS 2050 cannot resume.
Storage This selection puts the JANUS 2050 in Storage mode to preserve the
life of the backup battery. You should put the JANUS 2050 in Storage mode
whenever the JANUS 2050 is not going to be used for a couple of months.
However, all RAM data is lost.
Off This selection exits the Boot Loader menu and puts the JANUS 2050 into
the suspend state. When the JANUS 2050 is turned on again, it resumes normal
operation.
39 nugget A Advanced Operations
11
11-5