Stop Bits - Intermec Janus 2050 User Manual

JANUS 2050 Vehicle-Mount Computer User's Manual (4MB)

Stop Bits

Purpose: Sets the number of stop bits on the communications port.
Note: You must select the communications port and protocol before setting the
parameters that define the protocol. Refer to the configuration command
"Communications Protocol, Configure" earlier in this chapter for more information on
defining protocols.
Default: 1 stop bit
Syntax: ICdata
Acceptable values for data are:
1
2
Scan: One of the following labels:
1 Stop Bit
*$+IC1*
*$+IC1*
2 Stop Bits
*$+IC2*
*$+IC2*
10-88
One stop bit
Two stop bits
39 nugget A