Using The Configuration Application - Intermec Janus 2050 User Manual

Using the Configuration Application

The configuration application is a menu-driven application that lets you
configure the JANUS 2050 and view system information. To open the
configuration application from the DOS prompt, type:
ic
Then press e .
Or, scan the following bar code:
*IC*
*IC*
In the menu bar, there are four drop-down menus:
Com Select the Com menu to set the communications protocol for each of the
JANUS 2050's COM ports and to define the parameters for each selected
protocol.
Op
2050. You can modify parameters and options for turning the JANUS 2050 on
and off, data manipulation, JANUS 2050 display, beeper control, keypad, and
scanner operation.
Note: When you are configuring the JANUS 2050 using the drop-down menus, press
l for online help.
nuggJVMU nugg
Configuration
File Sym Com Op
Load...
Load Default
Save
Save As...
About
Exit
?
Select the Op menu to change the operating parameters for the JANUS
JVMUConfiguring the JANUS 2050
File Select the File menu to load or
save configuration files, or return to the
default configuration. You can also
display software versions, equipment
information, and available memory. You
quit the configuration application by
selecting Exit from this menu.
Sym
Select the Sym menu to enable or
disable decoding of bar code
symbologies. Some of the symbologies
also allow you to determine the check
2050U.060
digit and label length.
4
4-7