Eom (End Of Message) - Intermec Janus 2050 User Manual

JANUS 2050 Vehicle-Mount Computer User's Manual (4MB)

EOM (End of Message)

Purpose: Attaches an EOM to the end of a data block to indicate the end of data
transmission to and from a JANUS 2050. You can disable the EOM transmit
and receive characters, define EOM transmit and receive to the same
characters, or define EOM transmit and receive to different characters.
Note: You must select the communications port and protocol before setting the
parameters to define that protocol. For help, see the configuration command
"Communications Protocol, Configure" earlier in this chapter.
Default: EOM Transmit and Receive are set to CR (0DH) and LF (0AH)
(carriage return line feed)
Syntax: PF
PFdata
PI
PIdata
PJ
PJdata
data can be one or two ASCII characters.
Scan: To disable EOM, scan one of these bar codes:
Disable EOM, Transmit and Receive
*$+PF*
*$+PF*
Disable EOM, Receive Only
*$+PJ*
*$+PJ*
Or: To set EOM transmit and receive to the same ASCII character:
1. Scan this bar code:
10-48
Disable transmit and receive EOM
Enable transmit and receive EOM
Disable transmit EOM only
Enable transmit EOM only
Disable receive EOM only
Enable receive EOM only
Enter Accumulate / Enable EOM, Transmit and Receive
*+/$+PF*
*+/$+PF*
39 nugget A
Disable EOM, Transmit Only
*$+PI*
*$+PI*