Intermec Janus 2050 User Manual page 385

JANUS 2050 Vehicle-Mount Computer User's Manual (4MB)
ASCII control character
One of the first 32 characters (0 through 31 in decimal representation) in the
ASCII character set. Each of these characters has a standard control function,
such as backspace or carriage return.
ATA flash PC card
A type of memory PC card that provides additional disk storage space, not
more executable conventional memory, on a JANUS device.
audio signals
The device has a beeper and a clicker that produce audio signals that indicate
device status. You can change the beep volume and enable or disable the
keypad clicker with configuration commands.
Auto-Loader
A DOS utility used to change the contents of drive C. You can also use it to
configure the device to operate in any language supported by DOS NLS
(National Language Support). You run Auto-Loader on a host computer
connected to the COM1 port.
automatic shutoff
A device configuration feature that defines the maximum length of time the
device stays on when there is no activity. At automatic shutoff, the contents of
device memory are saved and the device resumes where it left off when it is
turned on again.
backlight
A light built into the device display to make it easier to view the device display
in dimly lit environments.
BAK
Bad Program Acknowledgment character. This character is sent from the
device to indicate that the IRL program received from the host could not be
successfully compiled.
bar code density
Number of data characters that can be represented in a linear unit of measure.
Often expressed in characters per inch.
bar code label
A label that contains a bar code symbol.
G-4