Lubricating The Windrower; Procedure; Lubrication Points - MacDon M150 2008 Operator's Manual

7.7 LUBRICATING THE WINDROWER

WARNING
To avoid personal injury, before servicing
windrower or opening drive covers, follow
procedures in Section 7.1, Preparation for
Servicing.
Recommend Lubricant
LUBRICANT SPEC
SAE Multi-
Grease
Purpose.
The greasing points are marked on the machine
by decals showing a grease gun and grease
interval in hours of operation. See illustration
below.
Log hours of
"Maintenance Checklist" provided to keep a
record of scheduled maintenance.
Section 7.15, Maintenance Schedule.
7.7.1

Procedure

DANGER
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
a. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
b. Inject grease through fitting with grease gun until
grease overflows fitting, except where noted.
c. Leave excess grease on fitting to keep out dirt.
d. Replace any loose
immediately.
e. If fitting will not take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
Form 169017
MAINTENANCE/SERVICE
DESCRIPTION USE
High Temp.
Extreme Pressure
(EP2)
As Required
Performance With
Unless
1% Max
Otherwise
Molybdenum
Specified.
Disulphide (NLGI
Grade 2).Lithium
Base
operation and use
Refer to
or broken fittings
7.7.2

Lubrication Points

Refer to the illustrations on the following page
for identifying the various locations that require
lubrication.
the
113
Issue – June 2008