Lubricating The Windrower; Lubrication Procedure - MacDon M155 Unloading And Assembly Instructions

3.22 Lubricating the Windrower

For grease specification, refer to the inside back cover of this book for quick reference.

3.22.1 Lubrication Procedure

DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator's seat for any reason.
1. Wipe grease fitting with a clean cloth before greasing to avoid injecting dirt and grit.
2. Inject grease through fitting with grease gun until grease overflows fitting. Do NOT overgrease wheel bearings.
3. Leave excess grease on fitting to keep out dirt.
4. Replace any loose or broken fittings immediately.
5. Remove and thoroughly clean any fittings (including the lubricant passageway) that will not take grease.
Replace fitting, if necessary.
214298
ASSEMBLING THE WINDROWER
140
Revision A