Table of Contents
Advertisement
DANGER
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
DANGER
To avoid bodily injury from fall of raised
header, always engage header lift cylinder
stops when working on or around raised
header.
d. Raise header to full height, stop engine, and
engage safety locks on lift cylinders.
e. Deploy header slow speed transport system.
See Header Operator's Manual.
f.
Remove float pin (B) from linkage to disengage
float springs, and insert in storage hole (C).
Secure with lynch pin.
g. Remove pins (D) from lower end of lift legs.
NOTE
Pins (D) are also used to secure weight
box to tractor linkage.
Form # 169017
WINDROWER TRACTOR OPERATION
C
B
D
66
h. Disconnect the center link as follows:
HYDRAULIC LINK – M200 STD, M150 OPTION
D60 SHOWN
E
1. Pull up on latch (E) and locate latch into
notch (F) on top of hook.
2. Release the safety lock on the header lift
cylinders.
3. Lower header down onto the transport
wheels
4. Disengage the top link from the header.
Use the header tilt switch to release load on
the cylinder if necessary.
NOTE
If optional self-alignment kit is installed,
the top link can be raised or lowered using
the Reel "UP" and "DOWN" buttons on the
GSL.
MECHANICAL LINK – M150
J
D60 SHOWN
1. Loosen nut (G) and rotate barrel (H) to
relieve load on link.
2. Remove cotter pin on pin (J), and remove
pin to disconnect from tractor. Re-install pin
in header.
i.
Back tractor away from header.
F
G
H
(continued next page)
Issue – June 2008
Advertisement
Table of Contents
