Table of Contents
Advertisement
CAUTION
Do not stand on the platform in the unlocked
position. It is unstable and may result in a fall.
e. Close platform as follows:
1. Swing link (C) all the way forward.
2. Move platform front (cab-forward) end inboard
while moving it away from the walking beam.
3. Position link (C) on bracket, and install bolt
and nut. Tighten just enough so that link can
still swivel on bracket.
4. Move platform to closed position, ensuring it is
locked.
f.
Close engine compartment hood.
7.6 LUBRICATING THE WINDROWER
WARNING
To avoid personal injury, before servicing
windrower or opening drive covers, follow
procedures in Section 7.1 Preparation for
Servicing.
The greasing points are marked on the machine
by decals showing a grease gun and grease
interval in hours of operation. See illustration
below.
Log hours of operation and use the "Maintenance
Checklist" provided to keep a record of scheduled
maintenance.
Refer
MAINTENANCE SCHEDULE.
169469/169470/169471
MAINTENANCE AND SERVICING
C
to
Section
7.13
132
7.6.1 LUBRICATION PROCEDURE
DANGER
Stop engine, and remove key from ignition
before leaving Operator's seat for any reason.
A child or even a pet could engage an idling
machine.
Lubricant
Spec
SAE Multi-
Grease
Purpose
a. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
b. Inject grease through fitting with grease gun until
grease overflows fitting, except where noted.
c. Leave excess grease on fitting to keep out dirt.
d. Replace any loose or broken fittings immediately.
e. If fitting will not take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
7.6.2 LUBRICATION POINTS
Refer to the illustrations on the following page for
identifying the various locations that require
lubrication.
Description
Use
High Temperature
Extreme Pressure
(EP2)
As
Performance With
Required
1% Max
Unless
Molybdenum
Otherwise
Disulphide (NLGI
Specified
Grade 2).
Lithium Base
Revision E
Advertisement
Table of Contents
