Table of Contents
Advertisement
6.5.2
Header Detachment - D Series
a. Raise the header fully with the header up switch
on the GSL. Stop engine and remove key.
HEADER
TILT DOWN
HEADER DOWN
DANGER
To avoid bodily injury from fall of raised
header, always engage header lift cylinder
stops when working on or around raised
header.
b. Engage lift cylinder stops on both lift cylinders.
C
A
c. Remove pin (A) from header leg on both sides.
d. Lower header stand (B) by pulling spring loaded
pin (C). Release pin to lock stand.
Form # 169017
HEADER OPERATION – D SERIES
HEADER UP
HEADER TILT UP
B
e. Remove pin (D) from linkage to disengage float
springs, and insert in storage hole (E). Secure
with lynch pin.
f.
Disengage lift cylinder stops.
g. Start engine, choose a level area and lower
header to the ground. Stop engine and remove
key.
M
h. Disconnect header drive hydraulics (L) and
electrical harness (M) from header. Refer to the
Draper Header Operator's Manual.
i.
Disconnect reel hydraulics (N) and store on
bracket at tractor LH side.
86
D
L
L
HEADER DRIVE HOSES
N
REEL HYDRAULICS
(continued next page)
Issue – June 2008
E
Advertisement
Table of Contents
