Table of Contents
Advertisement
7.10.8.2 Changing Lubricant
Change gearbox lubricant after the first 50 hours
and then at 500 hours as follows:
The engine should be warm prior to
changing the oil.
DANGER
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
a. Stop the engine and remove the key.
b. Place a drain pan of about 1 U.S. gallons (4
litres) under the gearbox.
A
c. Remove drain plug (C) and allow the oil to
completely finish draining.
d. Install the drain plug (C) and remove the check
plug (A).
Form 169017
MAINTENANCE/SERVICE – M200 ENGINE
NOTE
C
e. Unscrew breather cap (B) and add lubricant.
The gearbox will require 2.2 U.S. quarts (2.1
litres).
runs out of hole (A).
Service
Transmission Lubricant. SAE J2360 preferred.
f.
Replace check plug (A).
g. Operate the engine at low idle for a short time
and shutdown.
h.
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
i.
Check for leaks at the check plug and drain
plug.
161
B
Add sufficient lubricant until it slightly
Use SAE 75W-90 API
Class
GL-5,
Fully
DANGER
Issue – June 2008
Synthetic
Advertisement
Table of Contents
