Table of Contents
Advertisement
6.4.6
Cutting Height
The header is raised or lowered with the
HEADER UP or HEADER DOWN switches on
the GSL. See illustration. The CDM indicates
the header height by a reading on the DISPLAY
lower line between 00.0 and 10.0, with 00.0
being
on
the
SELECTOR switch to display the current setting.
HEADER UP
HEADER DOWN
6.4.6.1
Return To Cut
The M Series monitoring system will assist the
operator in maintaining the desired cutting
height with the RETURN TO CUT feature that
can be turned off or on with a switch on the
CDM.
The RETURN TO CUT feature enables the
operator to have the header return to a pre-
selected cutting height and angle. If desired, the
CDM can be programmed so that only the
cutting height feature is active. The unit is pre-
programmed to activate both cutting height and
header angle.
Form 169017
HEADER – GENERAL
ground.
Use
DISPLAY
DISPLAY
DISPLAY
SELECTOR
a. Program the RETURN TO CUT feature as
follows:
The windrower must be running with the
header engaged.
RETURN TO
CUT
HEADER UP
HEADER
TILT DOWN
1. RETURN TO CUT switch must be off
(indicator light is off).
2. Adjust the header to the desired height with
the HEADER UP or HEADER DOWN
switches on the GSL.
between 00.0 and 10.0.
3. Adjust the header angle with the HEADER
TILT UP or HEADER TILT DOWN switches
on the GSL. CDM displays between .0 and
10.0. This step is not required if height only
has been pre-selected.
4. Press the RETURN TO CUT switch on the
CDM. The indicator light will illuminate and
the settings are now programmed into the
WCM.
b. Use the RETURN TO CUT feature as follows:
Ensure the header is engaged and the
RETURN TO CUT switch is illuminated.
The header can be raised or lowered at
any time by depressing and holding the
HEADER
switches on the GSL.
1. If header is above the pre-set height,
momentarily
switch and header will return to pre-set
height.
81
IMPORTANT
DISPLAY
HEADER
TILT UP
HEADER DOWN
CDM displays
IMPORTANT
NOTE
UP
or
HEADER
press
HEADER
(continued next page)
Issue – June 2008
DOWN
DOWN
Advertisement
Table of Contents
