Table of Contents
Advertisement
6.7 R SERIES HEADER OPERATION
6.7.1
Header Attachment – R Series
a. Remove hairpin from pin (A), and remove pin
from on left and right header boots (B) on
header.
CAUTION
Check to be sure all bystanders have cleared
the area.
HEADER
TILT DOWN
HEADER DOWN
b. Start the engine and activate header down
button on the GSL to fully retract header lift
cylinders.
Form 169017
HEADER OPERATION – R SERIES
A
HEADER UP
HEADER TILT UP
c. Slowly drive tractor forward so that feet (C) on
tractor enter boots (B) on the header. Continue
to drive slowly forward until feet engage the
boots, and header nudges forward.
d. Connect center link as follows:
MECHANICAL LINK – M150
B
1. Loosen nut (D) and rotate barrel (E) to
adjust length so that other end lines up with
header bracket.
2. Install clevis pin (F) and secure with cotter
pin.
3. Adjust link to required length for proper
header angle by rotating barrel (E). Tighten
nut (D) against barrel. A slight tap with a
hammer is sufficient.
101
C
B
D
E
E
F
(continued next page)
Issue – June 2008
Advertisement
Table of Contents
