Table of Contents
Advertisement
INTERVAL
FIRST USE
1. Change Fuel Tank Vent Line Filter.
2. Check Battery Fluid Level.
3. Check Battery Charge.
ANNUALLY *
4. Check Anti-Freeze Concentration.
5. Cycle A/C Blower Switch To Distribute Refrigerant Oil.
6. Check Safety Systems (or 500 hours whichever occurs first).
END OF
SEASON
1. Check Tire Inflation.
2. Check Engine Oil Level.
3. Check Engine Coolant Level At Reserve Tank.
10 HOURS OR
4. Clan Radiator, Hydraulic Oil Cooler, Charge Air Cooler, And A/C Condenser.
DAILY
5. Check Hydraulic Oil Level.
6. Drain Fuel Filter Water Trap.
7. Fill Fuel Tank.
8. Check Hydraulic Hoses And Lines For Leaks.
1. Grease Caster Pivots.
2. Grease Walking Beam Center Pivot.
3. Grease Top Lift Link Pivots.
50 HOURS
4. Grease Forked Caster Spindle Bearings.
5. Clean Cab Fresh Air Intake Filter.
6. Check Gear Box Oil Level.
100 HOURS OR
1. Clean Cab Air Return Filter.
ANNUALLY *
1. Check Drive Wheel Lubricant Level.
200 HOURS OR
2. Grease Formed Caster Wheel Hub Bearings.
ANNUALLY *
3. Check Wheel Nut Torque.
1. Change Engine Oil And Filter.
2. Change Fuel Filters.
3. Change Gearbox Lubricant.
4. Change Hydraulic Oil Filters.
500 HOURS
5. Check Engine Valve Tappet Clearance - Initial (M200 ONLY).
6. Change Engine Air Cleaner Filter Element (M200 ONLY).
7. Change Crankcase Breather (M200 ONLY).
1. Change Engine Air Cleaner Filter Element (M150 ONLY).
1000 HOURS
2. Change Drive Wheel Lubricant
3. Check Engine Valve Tappet Clearance.
1.
2000 HOURS
2. Perform General Engine Inspection
3. Change Engine Coolant (M150 ONLY).
3000 HOURS
1. Change Engine Coolant (M200 ONLY).
* IT IS RECOMMENDED THAT ANNUAL MAINTENANCE BE DONE PRIOR TO START OF OPERATING
SEASON.
Form # 169017
MAINTENANCE/SERVICE
Refer To Section 6.3.2 BREAK-IN PERIOD.
Refer To Section 6.3.9 STORAGE.
Change Hydraulic Oil.
SERVICE
.
198
Issue – June 2008
Advertisement
Table of Contents
