Table of Contents
Advertisement
6.4.3
Levelling
The tractor linkages are factory set to provide
the proper level for the header and should not
normally require adjustment. If the header is not
level, perform the following checks prior to
adjusting the leveling linkages. The float springs
are not used to level the header.
a. Check windrower tractor tire pressures.
b. Check and set float adjustment.
previous sections.
Level header as follows:
c. Park windrower on level ground.
A
d. Set header approximately 6 inches (150 mm) off
ground and check that member (A) is against
link (B). Note high and low end of header.
e. Place wooden blocks under header cutterbar
and legs, and lower header onto blocks so that
members (A) lift off links (B). Stop engine.
DANGER
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
f.
On high side, remove nut, washer and bolt (C)
that attaches shims (D) to link.
g. Remove one or both shims (D) and reinstall the
hardware (C).
CAUTION
Check to be sure all bystanders have cleared
the area.
h. Start engine and raise header slightly. Check
level of header.
i.
If additional levelling is required, install the
removed shim on the opposite linkage.
Form # 169017
HEADER – GENERAL
Refer to
C
D
B
78
NOTE
If required, additional shims are available
from your dealer
NOTE
Float does not require adjustment after
levelling header.
Issue – June 2008
Advertisement
Table of Contents
