Table of Contents
Advertisement
A
c. Loosen compressor mounting hardware (B) and
push compressor towards engine to release belt
(A) tension.
d. Remove belt (A).
1
e. Insert the drive end of a ½ inch drive ratchet
wrench into the belt tensioner (C).
f.
Rotate tensioner counterclockwise until fan belt
(D) can be slipped off pulley (E).
tensioner and remove wrench.
g. Remove belt in order 1-2-3 as shown. Route fan
belt around fan and remove belt.
h. Install new belt (D) around fan and onto pulleys
in order 3-2-1.
i.
Insert the drive end of a ½ inch drive ratchet
wrench into the belt tensioner (C).
j.
Rotate tensioner counterclockwise until belt (D)
can be slipped onto pulley (E).
tensioner and remove wrench.
k. Check that belt is properly seated in all pulley
grooves.
Form # 169017
MAINTENANCE/SERVICE – M150 ENGINE
B
D
2
E
C
3
Release
Release
l.
Install A/C compressor belt (A) on pulleys.
m. Pry compressor away from engine so that a
force of 8 to 12 lbf (35-55 N) deflects the belt (A)
3/16 inch (5 mm) at mid-span.
n. Tighten compressor mounting hardware (B).
o. Recheck tension and re-adjust as required.
p. Move maintenance platforms to working position
and close engine compartment hood.
142
A
B
Issue – June 2008
Advertisement
Table of Contents
