Table of Contents
Advertisement
7.10.4
Air Intake System
IMPORTANT
Do not run engine with air cleaner
disconnected or disassembled.
B
C
A
Engine intake air is drawn through a duct (A)
from the cooling box that pre-cleans the air, and
then through a dual element filter (B). The air
cleaner canister is equipped with a duct (C) that
removes dust continuously from the air cleaner
housing. The air cleaner is also equipped with a
restriction switch (D) which activates a warning
light on the CDM with an alarm when the
primary filter element requires cleaning.
The warning light could activate when
operating in extremely dirty conditions, in
which case the filter element should be
cleaned.
Under
conditions, filter servicing should be
performed at the specified interval. Refer
to Section 7.15, Maintenance Schedule.
Form 169017
MAINTENANCE/SERVICE – M200 ENGINE
D
NOTE
normal
operating
7.10.4.1 Air Filter Servicing
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
a. Open engine compartment hood to highest
position.
b. Lift catch (E) on top of cap and rotate end cap
(F) counterclockwise until it stops and arrow (G)
lines up with unlock symbol on end cap. Pull off
the end cap.
c. Pull out the primary filter element (H) and
inspect as follows:
147
DANGER
F
H
(continued next page)
Issue – June 2008
G
E
Advertisement
Table of Contents
