Table of Contents
Advertisement
CAUTION
Do not stand on the platform in the unlocked
position. It is unstable and may result in a
fall.
e. Close platform as follows:
1. Swing link (D) all the way forward.
2. Move platform front end inboard while
moving it away from the walking beam.
3. Position link (D) on bracket, and install bolt
and nut. Tighten just enough so that link
can still swivel on bracket.
4. Move platform to closed position, ensuring it
is locked.
f.
Close engine compartment hood.
7.6 LUBRICATING THE WINDROWER
WARNING
To avoid personal injury, before servicing
windrower or opening drive covers, follow
procedures in Section 7.1 PREPARATION
FOR SERVICING.
The greasing points are marked on the machine
by decals showing a grease gun and grease
interval in hours of operation. See illustration
below.
Form 169552 / 169554 / 169555
MAINTENANCE AND SERVICING
D
117
Recommended Lubricant:
LUBRICANT
SPEC
SAE
Grease
Multi-
Purpose.
Log hours of operation and use the Maintenance
Checklist
provided
scheduled maintenance. Refer to Section 7.13
MAINTENANCE SCHEDULE.
7.6.1
PROCEDURE
DANGER
Stop engine, and remove key from ignition
before leaving Operator's seat for any
reason. A child or even a pet could engage
an idling machine.
a. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
b. Inject grease through fitting with grease gun until
grease overflows fitting, except where noted.
c. Leave excess grease on fitting to keep out dirt.
d. Replace
any
loose
immediately.
e. If fitting will not take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
7.6.2
LUBRICATION POINTS
Refer to the illustrations on the following page to
identify the various locations that require
lubrication.
DESCRIPTION
USE
High Temperature
Extreme Pressure
(EP2)
As
Performance With
Required
1% Max
Unless
Molybdenum
Otherwise
Disulphide (NLGI
Specified.
Grade 2).
Lithium Base.
to
keep
a
record
or
broken
fittings
Revision A
of
Advertisement
Table of Contents
