Engine Compartment Hood - MacDon M150 2008 Operator's Manual

7.5 ENGINE COMPARTMENT HOOD

The engine hood has two open positions. The
lowest is for general maintenance such as
checking and adding fluid, servicing the cooling
box, etc. The highest position accommodates
full access to the engine bay
a. Open the hood at the lowest position as follows:
B
1. Locate latch (A) behind grill and lift to
release hood.
2. Raise hood until strap (B), which should be
looped under hooks (C) and (D), stops it at
approximately a 40° angle.
b. To close hood:
1. Pull down on strap (B), grasp the hood when
within reach and lower until hood engages
latch (A).
Form # 169017
MAINTENANCE/SERVICE
C
D
A
c. Open the hood at the highest position as follows:
1. Open hood to lowest position.
2. Remove strap from hooks (C) and (D) and
allow hood to raise fully to approximately 65°
d. To close hood:
1. Grasp the strap at (B) and loop under upper
hook (C).
2. Pull down on strap and loop under lower
hook (D).
Failure to hook strap may result in it
becoming entangled with the screen
cleaners or the latch.
3. Pull down on strap, grasp the hood when
within reach and lower until hood engages
latch (A).
110
B
C
D
IMPORTANT
Issue – June 2008