Table of Contents
Advertisement
7.10.6
Fuel System
7.10.6.1 Fuel Tank Venting
The fuel tank is vented by a hose that is
connected to the filler tube.
connected to a filter that should be changed
annually. Change the filter as follows:
DANGER
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
WARNING
To avoid personal injury or death from
explosion or fire, do not smoke or allow
flame or sparks near windrower when
servicing.
a. Open engine compartment hood to highest
position.
B
b. Locate filter (A) on vent line against hydraulic oil
reservoir.
c. Release hose tension clamps (B) and slide away
from filter. Pull hoses off filter.
d. Position new filter through hole in frame and
attach top hose onto filter. "IN" marking should
face down.
Form 169017
MAINTENANCE/SERVICE – M200 ENGINE
The hose is
A
151
NOTE
If filter has an arrow instead of an IN
marking, arrow should point up.
e. Attach lower hose to filter and secure both
hoses with tension clamps (B).
7.10.6.2 Fuel Filters
C
The M200 tractor fuel system is equipped with
primary (C) and secondary (D) filters.
filters are screw-on cartridge type but the
primary (C) filter is equipped with a separator
that separates sediment and water from the fuel.
Change both filters as follows every 500 hours
of operation:
D
Both
(continued next page)
Issue – June 2008
Advertisement
Table of Contents
