Options / Attachments - MacDon M150 2008 Operator's Manual

9 OPTIONS / ATTACHMENTS

9.1 REEL DRIVE & LIFT PLUMBING
Reel drive and lift plumbing for draper headers
on tractors that are shipped from the factory in
auger header configuration.
instructions are included.
9.2 TRACTOR HYDRAULIC
COMPLETION FOR DRAPER
HEADER REEL FORE/AFT
Allows reel fore/aft hydraulic adjustment for
draper headers on tractors that are shipped from
the factory in auger header configuration. Kit
includes valve for selection of reel fore/aft or
double windrow
Installation instructions are included.
9.3 DOUBLE WINDROW ATTACHMENT
Allows auger header windrower to lay a double
windrow. Installation instructions are included.
9.4 REVERSER VALVE AND
PLUMBING
Allows the header drive direction to be reversed
on both draper and auger headers to assist in
unplugging the header.
components on the auger header can operate in
the opposite direction. On the draper header,
only the drapers, conditioner and knife are
reversible. Installation instructions are included.
9.5 BOOSTER SPRING KIT
Available for headers over 6000 lb (2724 kg).
Installation instructions are included.
9.6 INTERNAL BOOSTER SPRING KIT
Internal spring for right side lift linkage to
improve float capacity. Standard equipment on
left side.
9.7 LIGHT HEADER FLOTATION KIT
Available for headers that do not require as
much spring tension for float.
instructions are included.
Form # 169017
OPTIONS
Installation
attachment functions.
With this option, all
Installation
210
9.8 WINDSHIELD SHADES
Retractable sun shades for front and rear
windows. Installation instructions are included.
9.9 DISC HEADER VALVE
Required for attaching a R80 Disc Header to
M150. Installation instructions are included.
9.10 AM-FM RADIO
Available for installation into pre-wired cab.
Speakers are factory installed.
Refer to M150
Windrower Unloading and Assembly Instructions
for installation instructions.
supplied with your windrower tractor.
9.11 CENTER LINK SELF-ALIGNMENT
KIT
Available for M150 and M200 equipped with
hydraulic center link.
cylinder to be hydraulically positioned and
connected to the header without leaving the
operator's station.
included.
9.12 PRESSURE SENSOR KIT
Monitors hydraulic pressure and warns of
overload conditions. Installation instructions are
included.
9.13 HYDRAULIC CENTER LINK
The hydraulic center link allows the operator to
adjust the header angle from the cab.
standard on the M200 and optional on the M150.
9.14 WEIGHT BOX
The weight box allows engine forward transport
in high range when the header is not attached.
9.15 TOWING HARNESS
The towing harness is used together with the
weight box if towing a D Series draper header
behind the windrower tractor is desired.
& M200 Self-Propelled
This instruction is
Allows the center link
Installation instructions are
Issue – June 2008
It is