Table of Contents
Advertisement
3.12 Lubricating Windrower
The windrower should have been greased at the factory, but the grease fittings will need to be inspected to ensure that
they are properly lubricated.
Ensure that the grease fittings indicated in the illustration below are lubricated. A single pump of grease should be
sufficient to confirm that the fitting has been lubricated.
For information on the type of lubricants to use, refer to
Follow this procedure to add grease to a fitting:
a.
Wipe the grease fitting with a clean cloth.
b. Inject grease into the fitting with a grease gun until grease overflows the greased component. Do NOT overgrease
the wheel bearings.
c.
If the fitting is loose or will not take grease, remove and clean the fitting, or replace it.
d. Leave a blob of excess grease on the fitting.
Figure 3.47: Lubrication Points
A - Top Link (Two Places) (Both Sides)
C - Forked Caster Wheel Bearing (Two Places) (Both Wheels)
262175
ASSEMBLING WINDROWER
A
Lubricants, Fluids, and System Capacities, page
B - Caster Pivot (Both Sides)
48
.
B
C
Revision A
Advertisement
Table of Contents
