Table of Contents
Advertisement
e. Change secondary filter (D) as follows:
M
1. Thoroughly clean around the filter head (L).
2. Remove filter (D) with a filter wrench.
3. Clean seal mating surface on filter head.
4. Do not lubricate O-ring seal or fill filter with
fuel.
5. Screw the new filter (D) onto the filter mount
until the gasket contacts the filter head.
6. Tighten the filter an additional ½ to ¾ turn by
hand.
IMPORTANT
Do not use a filter wrench to install the
filter.
Over-tightening can damage the
gasket and filter.
E
f.
Open fuel valve (E) under fuel tank.
g. Push the priming pump (M) until glass bowl is
full and resistance is felt on the pump. If engine
does not start, repeat this procedure.
h. Close engine compartment hood.
Form 169017
MAINTENANCE/SERVICE – M200 ENGINE
L
D
153
7.10.6.3 Separator
A fuel water separator is incorporated into the
primary fuel filter. Drain the water and sediment
as follows from the separator daily.
DANGER
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
a. Stop engine and remove key.
B
b. Place a suitable container under primary filter.
Install a suitable tube onto the water separator
drain (B).
c. Turn drain valve (B) by hand 1½ to 2 turns
counterclockwise and allow fluid to drain into the
container.
d. Drain the filter sump of water and sediment until
clear fuel is visible in glass bowl.
e. Turn the valve clockwise to close the drain.
Issue – June 2008
Advertisement
Table of Contents
