Table of Contents
Advertisement
7.12.2
Headlights – Engine Forward
DANGER
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
NOTE
Header should be attached and raised to
maintain proper tractor stance.
7.12.2.1 Alignment
a. Position tractor on level ground in front of a
vertical
surface
illustration.
b. Shutdown engine and remove the key.
A
c. Turn on the headlights (A) and switch to lo-
beam.
Form 169017
MAINTENANCE/SERVICE
in
accordance
with
B
d. Align
specifications by turning adjusting screws (B).
•
Adjustments are for lo-beam.
•
Light beams laterally centered on the
"direction of travel" line from the headlights
(i.e. not skewed left or right).
•
Upper limit of the beam not higher than 49¾
inches (1263 mm) above ground at a
distance of 25 ft. (7.5 m) from the headlight.
the
7.12.2.2 Bulb Replacement
a. Remove the two screws (C) and remove
headlight assembly from hood.
b. Pull wiring harness connector off the headlight
assembly and remove rubber insulator boot (D).
175
the
headlights
to
C
D
(continued next page)
Issue – June 2008
the
following
49.75 in.
(1263 mm)
maximum
Advertisement
Table of Contents
