Table of Contents
Advertisement
g. Add oil as follows if level is below the LOW
mark: One U.S. qt. (1 litre) will raise the level
from LOW to HIGH.
CAUTION
Do not fill above the HIGH mark.
1. Turn cap (A) counterclockwise, and remove
filler cap.
A
2. Carefully pour the oil.
Compliant With SAE Specs for API Class SJ
and CH-4 Engine Oil.
recommended to avoid spillage.
3. Replace oil filler cap (A) and turn clockwise
until snug.
h. Close engine compartment hood.
Form 169017
MAINTENANCE/SERVICE – M200 ENGINE
Use SAE 15W40
A funnel is
145
7.10.3
Changing Oil and Oil Filter
NOTE
The engine should be warm prior to
changing the oil.
a. Stop the engine and remove the key.
b. Open engine compartment hood to lowest
position.
c. Place a drain pan of about 5 U.S. gallons (20
litres) under the engine oil drain (B).
d. Remove oil pan drain plug (B) and allow the oil
to completely finish draining.
e. Check the condition of the used oil. If either of
the following is evident, have your dealer correct
the problem before starting the engine:
f.
Thin black oil indicates fuel dilution.
g. Milky discoloration indicates coolant dilution.
C
h. Clean around the filter head (C).
i.
Remove filter (D) with a filter wrench.
B
D
(continued next page)
Issue – June 2008
Advertisement
Table of Contents
