Table of Contents
Advertisement
2. If the header is below the pre-set height,
press and hold the HEADER UP switch to
raise the header. Release switch to stop
header. Alarm will sound when header rises
past the pre-set height.
3. If the header angle is changed, double click
(two clicks within 0.5 seconds) the HEADER
TILT UP or HEADER TILT DOWN switch
and the header will return to the pre-set
angle.
NOTE
If the header cannot return to the pre-set
height or angle within 30 seconds, the
RETURN TO CUT feature will deactivate
to
prevent
the
overheating. Push the RETURN TO CUT
switch to reactivate.
Form # 169017
HEADER – GENERAL
hydraulic
oil
from
82
Issue – June 2008
Advertisement
Table of Contents
